Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Owners Manual: Automatic Locking Retractor/Emergency Locking Retractor (ALR/ELR)

Subaru Legacy BN/BS (2015-2019) Owners Manual / Seat, seatbelt and SRS airbags / Seatbelts / Automatic Locking Retractor/Emergency Locking Retractor (ALR/ELR)

Each passenger's seatbelt has an Automatic Locking Retractor/Emergency Locking Retractor (ALR/ELR). The Automatic Locking Retractor/Emergency Locking Retractor normally functions as an Emergency Locking Retractor (ELR). The ALR/ ELR has an additional locking mode, "Automatic Locking Retractor (ALR) mode", intended to secure a child restraint system.

The ALR mode functions as follows.

When the seatbelt is once drawn out completely and is then retracted even slightly, the retractor locks the seatbelt in that position and the seatbelt cannot be extended. As the belt is rewinding, clicks will be heard which indicate the retractor functions as an ALR. When the seatbelt is retracted fully, the ALR mode is canceled and the ELR mode is restored.

When securing a child restraint system on the rear seats by using a seatbelt, the seatbelt must be changed over to the Automatic Locking Retractor (ALR) mode.

For instructions on how to install the child restraint system using a seatbelt, refer to "Installing child restraint systems with ALR/ELR seatbelt" .

When the child restraint system is removed, make sure that the retractor is restored to the Emergency Locking Retractor (ELR) mode by allowing the seatbelt to retract fully.

Seatbelt warning light and chime

Refer to "Seatbelt warning light and chime"

Seatbelt safety tips
WARNING  All persons in the vehicle should fasten their seatbelts BEFORE the vehicle starts to move. Otherwise, the possibility of serious injury becomes greater in the ...

Fastening the seatbelt
WARNING  Never use a belt that is twisted or reversed. In an accident, this can increase the risk or severity of injury.  Keep the lap belt as low as possible on y ...

Other materials:

Inspection
1. THROTTLE SENSOR (METHOD WITH CIRCUIT TESTER)1. Disconnect the ground terminal from battery sensor. NOTE2. While pressing the section (A) shown in the figure, move the lock lever (B) in the direction of the arrow to disconnect the connectors from the ECM in numerical order as shown in the figure. ...

© 2017-2024 Copyright www.sulegacy.com