Subaru Legacy BN/BS (2015-2019) Service Manual: Basic diagnostic procedure procedure

Subaru Legacy BN/BS (2015-2019) Service Manual / Power seat memory system (diagnostics) / Basic diagnostic procedure procedure

STEP	CHECK	YES	NO
1.PERFORM CUSTOMER INTERVIEW. Using the Check List for Interview, ask the customer the condition of how the trouble occurred.	Did you interview the customer-	Basic Diagnostic Procedure > PROCEDURE	Interview the customer. Check List for Interview > CHECK
2.CHECK LAN SYSTEM. Inspect LAN system. Basic Diagnostic Procedure > PROCEDURE	Is there any fault-	Perform the inspection according to the diagnosis for LAN system.	Basic Diagnostic Procedure > PROCEDURE
3.CHECK POWER SEAT MEMORY SYSTEM. Using the Subaru Select Monitor, read DTC of power seat memory system. Read Diagnostic Trouble Code (DTC) > OPERATION	Is DTC displayed-	Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC) > LIST After the repair, Basic Diagnostic Procedure > PROCEDURE	Basic Diagnostic Procedure > PROCEDURE
4.CHECK THE LIST OF TROUBLE SYMPTOMS. Check “TROUBLE SYMPTOM” for the power seat system. Power Seat System > INSPECTION	Does the symptom apply-	Perform the diagnosis according to the inspection procedures.	Currently, system is normal. The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
5.PERFORM INSPECTION MODE. Perform the Inspection Mode. Inspection Mode	Is DTC displayed-	Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC) > LIST	Finish the diagnosis.

Power seat memory system (diagnostics)

...

Check list for interview check

• Inspect the following items regarding the vehicle’s state.• Print out this page for interviewing customers.Power Seat Memory System Check List for Interview ...

Other materials:

Inspection
1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard1 — 2Switch OFF1 M- or moreSwitch ONLess than 1 -2 — 3Switch doorLess than 1 -2. Replace the light assembly - luggage room if the inspection result is not within the stan ...