Subaru Legacy BN/BS (2015-2019) Service Manual: Caution
• Prior to starting work, pay special attention to the following: 1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary. 2. Protect the vehicle using a seat cover, fender cover, etc. 3. Prepare the service tools, clean cloth, containers to catch grease and oil, etc. • Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts. • When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement. • Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. • Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle. • Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly. • Keep the removed parts in order and protect them from dust and dirt. • All removed parts, if to be reused, should be reinstalled in the original positions with attention to the correct directions, etc. • Bolts, nuts and washers should be replaced with new parts as required. • Be sure to tighten the fasteners including bolts and nuts to the specified torque. |
Specification
ItemSpecificationsIgnition coilTypeFK0463Ignition systemIndependent ignition coilManufacturerDiamond ElectricSpark plugManufacturer and typeNGK: SILZKAR7B11Thread size (diameter, pitch, length)mm12, 1 ...
Component
(1)Spark plug(2)Ignition coilTightening torque: N·m (kgf-m, ft-lb) T1:8.0 (0.8, 5.9) T2:18 (1.8, 13.3) ...
Other materials:
Assembly
1. FORWARD CLUTCH ASSEMBLY1. Install the forward clutch piston to forward clutch drum.NOTE:• Apply CVTF to the seal of forward clutch piston.• Insert it all the way to the end.2. Install the return spring.3. Install the chamber COMPL.NOTE:Apply CVTF to the sealing area of chamber COMPL.4 ...
