Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b1437 air mix door actuator circuit short-circuit (passenger)

Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc b1437 air mix door actuator circuit short-circuit (passenger)

DTC DETECTING CONDITION:

Air mix door actuator potentiometer circuit is shorted.

TROUBLE SYMPTOM:

Temperature of the passenger’s side cannot be adjusted for model with left/right independent air conditioner.

WIRING DIAGRAM:

Air conditioning system Air Conditioning System > WIRING DIAGRAM

STEP	CHECK	YES	NO
1.CHECK CONNECTOR. 1) Check connecting condition of the A/C CM connector and air mix door actuator RH connector. 2) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)	Is B1437 displayed-	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1437 AIR MIX DOOR ACTUATOR CIRCUIT SHORT-CIRCUIT (PASSENGER)	Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again. NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2.CHECK ACTUATOR. 1) Disconnect the air mix door actuator RH. 2) Read the DTC of the A/C CM using the Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)	Is B1436 displayed-	Replace the air mix door actuator RH. Air Mix Door Actuator > REMOVAL	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1437 AIR MIX DOOR ACTUATOR CIRCUIT SHORT-CIRCUIT (PASSENGER)
3.CHECK HARNESS. 1) Turn the ignition switch to ON. 2) Using the tester, measure the voltage between terminals. Connector & terminal (i175) No. 3 (+) — No. 1 (−):	Is the voltage 4.5 — 5.0 V-	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1437 AIR MIX DOOR ACTUATOR CIRCUIT SHORT-CIRCUIT (PASSENGER)	Repair or replace the open circuit of harness.
4.CHECK HARNESS (SHORTED BETWEEN LINES AND SHORTED TO GROUND). 1) Disconnect the connector from A/C CM. 2) Using a tester, check continuity between terminals. Connector & terminal (i175) No. 1 — No. 5: (i175) No. 5 — Chassis ground:	Is there continuity-	Repair or replace the short circuit of the harness.	Replace the A/C CM. Control Unit > REMOVAL

Dtc b1438 mode door actuator circuit open

DTC DETECTING CONDITION:Mode door actuator potentiometer circuit is open.TROUBLE SYMPTOM:Vent does not change.WIRING DIAGRAM:Air conditioning system Air Conditioning System > WIRING DIAGRAMSTEPCHECKY ...

Dtc b1436 air mix door actuator circuit open (passenger)

DTC DETECTING CONDITION:Air mix door actuator potentiometer circuit is open.TROUBLE SYMPTOM:Temperature of the passenger’s side cannot be adjusted for model with left/right independent air condi ...

Other materials:

Installation
1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH1. Install the back-up light switch & neutral position switch with the harness.NOTE:Use a new gasket.Tightening torque:32.3 N·m (3.3 kgf-m, 23.8 ft-lb)(A)Neutral position switch(B)Back-up light switch2. Lower the vehicle.3. Connect the connectors of ...