Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc b2512 damper breakage

DTC DETECTING CONDITION:

Abrupt drop in the rear gate has been detected after PRG operation stopped.

TROUBLE SYMPTOM:

Does not hold at the full-open position.

STEPCHECKYESNO

1.CHECK REAR GATE CONDITION.

Check the rear gate.

Is there any non genuine parts equipped to the rear gate- Or does it have foreign objects such as snow-

Remove non genuine parts or foreign objects. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2512 DAMPER BREAKAGE

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2512 DAMPER BREAKAGE

2.CHECK REAR GATE.

Hold the rear gate at the fully open position.

Does it hold at the fully open position-

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B2512 DAMPER BREAKAGE

Replace the rear gate damper stay. Rear Gate > REMOVAL

3.CHECK PRG CM.

1) Close the rear gate fully.

2) Press the operation switch to perform the auto-open operation to a full open position.

3) Repeat the auto-open operation at least three times.

4) Turn the ignition switch to ON.

5) Using the Subaru Select Monitor, read DTC of PRG CM. Read Diagnostic Trouble Code (DTC)

Is DTC B2512 displayed- (Current malfunction)

Replace the PRG CM. Power Rear Gate Control Module

Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE:

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Dtc b2513 latch condition
DTC DETECTING CONDITION:When the status of power rear gate auto closer changes differently from normal condition.TROUBLE SYMPTOM:Auto-operation does not function.WIRING DIAGRAM:Power rear gate system ...

Dtc b2511 rotation sensor pulse/reverse direction
DTC DETECTING CONDITION:When output of the power rear gate drive unit rotation sensor is different from the direction that it should be.TROUBLE SYMPTOM:Auto-operation does not function.WIRING DIAGRAM: ...

Other materials:

Dtc p0058 a/f / o2 heater control circuit low bank 2 sensor 2
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...

© 2017-2024 Copyright www.sulegacy.com