Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc c1984 brake maintenance mode

DTC DETECTING CONDITION:

This malfunction is stored when the brake maintenance mode is in progress.

TROUBLE SYMPTOM:

Parking brake system does not operate.

STEPCHECKYESNO

1.CHECK ELECTRONIC PARKING MODE.

Is the brake maintenance mode in progress-

Currently, it is normal. This DTC is stored when the brake maintenance mode is in progress. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > MAINTENANCE MODE DTC will be cleared when the maintenance mode is finished by following the procedure.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1984 BRAKE MAINTENANCE MODE

2.CHECK OPERATION OF ELECTRONIC PARKING BRAKE.

1) Perform the Clear Memory Mode. Clear Memory Mode

2) Apply the electronic parking brake several times.

3) Read the DTC. Read Diagnostic Trouble Code (DTC)

Is DTC stored even though the electronic parking brake operates-

Replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C1984 BRAKE MAINTENANCE MODE

3.CHECK DETECTION OF OTHER DTCS FOR VDC.

Read Diagnostic Trouble Code (DTC)

Is any other DTC displayed-

Perform the diagnosis according to DTC. List of Diagnostic Trouble Code (DTC)
Perform the diagnosis from step 1 again, and if the same DTC is stored, replace the VDCCM&H/U. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)

Currently, it is normal. Temporary interference from noise is a possible cause.

Dtc c1985 forbidden state of dynamic actuator operation
DTC DETECTING CONDITION:This malfunction is stored if dynamic parking through the electronic parking brake actuator does not operate.TROUBLE SYMPTOM:Parking brake system does not operate.STEPCHECKYESN ...

Dtc c1983 high frequency operation
DTC DETECTING CONDITION:This malfunction is stored if the electronic parking brake is operated with high frequency in a short period of time.TROUBLE SYMPTOM:Parking brake system does not operate somet ...

Other materials:

Installation
1. Install the fuel pump assembly to the fuel tank.CAUTION:Set the arm and float of the fuel level sensor while paying attention to prevent them from contacting the fuel tank. If the arm of the fuel level sensor is bent, the fuel gauge may not read correctly.NOTE:Use a new gasket.(1) Make sure the s ...

© 2017-2024 Copyright www.sulegacy.com