Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc c2533 control module board temperature sensor

Subaru Legacy BN/BS (2015-2019) Service Manual / Power assisted system (power steering) (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc c2533 control module board temperature sensor

DTC DETECTING CONDITION:

When thermistor malfunction is detected after the ignition switch is ON.

TROUBLE SYMPTOM:

The steering wheel operation feels heavy.

NOTE:

When this code is displayed, replace the steering gearbox with a new part. Electric Power Steering Gearbox

Dtc c2541 vehicle dynamics control module vehicle speed sensor

DTC DETECTING CONDITION:When VDCCM reception failure (related to vehicle speed sensor) is detected after the ignition switch is ON.TROUBLE SYMPTOM:The steering wheel operation feels heavy.STEPCHECKYES ...

Dtc c2532 control module peripheral circuit

DTC DETECTING CONDITION:• When torque sensor peripheral circuit malfunction inside the power steering control module is detected after assist starts with 500 rpm engine speed reception.• W ...

Other materials:

Inspection
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A), and loosen the clamps (B) and (C).3. Remove the air intake boot, and move it to the left side wheel apron.4. Disconnect the transmission radio ground terminal and transmission harness connector, and remove the harnes ...