Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc u0002 can communication error

Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc u0002 can communication error

DTC DETECTING CONDITION:

• Data to be received via CAN communication do not arrive.

• A/C cooperation control does not operate.

TROUBLE SYMPTOM:

A/C does not operate fully automatically.

STEP	CHECK	YES	NO
1.CHECK LAN SYSTEM. Check LAN system using the Subaru Select Monitor. Basic Diagnostic Procedure	Is there any fault-	Perform the diagnosis according to the inspection for LAN system.	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0002 CAN COMMUNICATION ERROR
2.CHECK A/C CM. 1) Replace with a normally operating A/C CM. 2) Read the DTC using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)	Is U0002 detected-	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0002 CAN COMMUNICATION ERROR	Replace the A/C CM. Control Unit > REMOVAL
3.CHECK CAN COMMUNICATION CIRCUIT. Check the CAN communication circuit. CAN Communication Circuit Check > LIST	Is the CAN communication circuit normal-	It is possible that temporary poor communication occurs. Clear the memory. Clear Memory Mode	Repair or replace the CAN communication circuit.

Diagnostic procedure with diagnostic trouble code (dtc)

...

Dtc b1430 in-vehicle (post evaporator) temperature sensor circuit open

DTC DETECTING CONDITION:In-vehicle sensor circuit is open.TROUBLE SYMPTOM:In-vehicle air temperature is falsely recognized as 25°C (77°F), and the compartment temperature is adjusted.WIR ...

Other materials:

Inspection mode procedure
It is possible to diagnose the DTC by performing the indicated inspection mode. After correcting the DTC, perform a necessary inspection mode and make sure that the function is resumed correctly and the DTC is recorded.1. INSPECTION MODE 1DTCItemNoteB2600LIN COMMUNICATION — B2601LIN CIRCUIT LOW � ...