Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc u0073 control module communication bus off

Subaru Legacy BN/BS (2015-2019) Service Manual / Lan system (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc u0073 control module communication bus off

DTC DETECTING CONDITION:

Integrated unit communication is shut down because of high speed CAN error.

TROUBLE SYMPTOM:

CAN communication is not normal.

STEP	CHECK	YES	NO
1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.	Was the basic diagnostic procedure performed up to STEP 8-	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0073 CONTROL MODULE COMMUNICATION BUS OFF	Perform the basic diagnostic procedure. Basic Diagnostic Procedure
2.CHECK DTC. 1) Start the engine. 2) Using the Subaru Select Monitor, read DTC of CAN system.	Is U0073 a current malfunction-	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0073 CONTROL MODULE COMMUNICATION BUS OFF	It may be a temporary poor contact. Perform the clear memory.
3.CHECK CAN COMMUNICATION CIRCUIT. Check CAN communication circuit. CAN Communication Circuit Check > PROCEDURE	Is CAN communication circuit faulty-	Repair the faulty portion, following the diagnosis procedure.	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0073 CONTROL MODULE COMMUNICATION BUS OFF
4.CHECK DTC. 1) Perform the inspection using the DTC check sheet. List of Diagnostic Trouble Code (DTC) > LIST 2) Using the Subaru Select Monitor, read DTC of CAN system.	Is U0073 a current malfunction-	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0073 CONTROL MODULE COMMUNICATION BUS OFF	System is normal.
5.CHECK CONTROL MODULE. 1) Turn the ignition switch to OFF. 2) Disconnect the control modules other than body integrated unit in order. NOTE: When disconnecting ECM or combination meter, connect resistance of 120 - between CAN Hi and CAN Lo as an alternative of end resistance. 3) Turn the ignition switch to ON. 4) Using the Subaru Select Monitor, read DTC of CAN system.	Is there any control module that U0073 is not detected as current malfunction-	Replace the control module.	Repeat 1) to 4) in step 3 until U0073 is not detected.

Dtc u0428 invalid data received from steering angle sensor module

DTC DETECTING CONDITION:Defective data was transmitted from steering angle sensor.TROUBLE SYMPTOM:VDC CM does not operate normally.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was th ...

Dtc u0427 invalid data received from vehicle security control module

DTC DETECTING CONDITION:Defective data was transmitted from keyless access CM.TROUBLE SYMPTOM:Cooperation control of keyless access does not operate properly.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC ...

Other materials:

Installation
1. Attach the ST to converter case.ST 498277200STOPPER SET2. When completely overhauling the transmission, refill approx. 10 L (2.6 US qt, 8.8 Imp qt) of CVTF through the transmission right side plug, and install the plug.CAUTION:Always use specified CVTF. Using other fluid will cause malfunction ...