Subaru Legacy BN/BS (2015-2019) Service Manual: Dtc u0074 control module communication bus "body-can" off

Subaru Legacy BN/BS (2015-2019) Service Manual / Lan system (diagnostics) / Diagnostic procedure with diagnostic trouble code (dtc) / Dtc u0074 control module communication bus "body-can" off

DTC DETECTING CONDITION:

Integrated unit communication is shut down because of high speed CAN error.

TROUBLE SYMPTOM:

CAN communication is not normal.

STEP	CHECK	YES	NO
1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.	Was the basic diagnostic procedure performed up to STEP 8-	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0074 CONTROL MODULE COMMUNICATION BUS "BODY-CAN" OFF	Perform the basic diagnostic procedure. Basic Diagnostic Procedure
2.CHECK DTC. 1) Start the engine. 2) Using the Subaru Select Monitor, read DTC of CAN system.	Is U0074 a current malfunction-	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0074 CONTROL MODULE COMMUNICATION BUS "BODY-CAN" OFF	It may be a temporary poor contact. Perform the clear memory.
3.CHECK CAN COMMUNICATION CIRCUIT. Check CAN communication circuit. CAN Communication Circuit Check > PROCEDURE	Is CAN communication circuit faulty-	Repair the faulty portion, following the diagnosis procedure.	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0074 CONTROL MODULE COMMUNICATION BUS "BODY-CAN" OFF
4.CHECK DTC. 1) Perform the inspection using the DTC check sheet. List of Diagnostic Trouble Code (DTC) > LIST 2) Using the Subaru Select Monitor, read DTC of CAN system.	Is U0074 a current malfunction-	Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0074 CONTROL MODULE COMMUNICATION BUS "BODY-CAN" OFF	System is normal.
5.CHECK CONTROL MODULE. 1) Turn the ignition switch to OFF. 2) Disconnect the control modules other than body integrated unit in order. NOTE: When disconnecting ECM or combination meter, connect resistance of 120 - between CAN Hi and CAN Lo as an alternative of end resistance. 3) Turn the ignition switch to ON. 4) Using the Subaru Select Monitor, read DTC of CAN system.	Is there any control module that U0074 is not detected as current malfunction-	Replace the control module.	Repeat 1) to 4) in step 3 until U0074 is not detected.

Dtc u0167 lost communication with immobilizer control module

DTC DETECTING CONDITION:No data is received from immobilizer.TROUBLE SYMPTOM:Immobilizer does not operate normally.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic diagnost ...

Dtc u0101 lost communication with tcm

DTC DETECTING CONDITION:No data is received from TCM.TROUBLE SYMPTOM:Cooperation control with transmission is not performed.STEPCHECKYESNO1.CHECK PERFORMING OF BASIC DIAGNOSTIC PROCEDURE.Was the basic ...

Other materials:

Dtc p0300 random/multiple cylinder misfire detected
DTC DETECTING CONDITION:• Detected when two consecutive driving cycles with fault occur.• Immediately at fault recognition (A misfire which could damage catalyst occurs.)TROUBLE SYMPTOM:• Engine stalls.• Improper idling• Rough drivingCAUTION:After servicing or replacing ...