Subaru Legacy BN/BS (2015-2019) Service Manual: Egr pipe

Installation

1. Install the EGR control valve, and connect the connector to the EGR control valve.NOTE:Use a new gasket.Tightening torque:19 N·m (1.9 kgf-m, 14.0 ft-lb)2. Install the EGR pipe A. EGR Pipe > ...

Removal

1. EGR PIPE A1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the collector cover.(1) Carefully pull up the rear of collector cover at two positions (A).(2) Carefully pull up the ...

Other materials:

Installation
1. Position the select cable as shown in the figure, and install it to the plate assembly.CAUTION:• If the cable is installed in the wrong direction, loosen the bracket bolts, and then reinstall the cable in the correct direction.• Do not adjust the cable end direction by turning it forc ...