Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Engine lubrication system trouble in general inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Lubrication(h4do) / Engine lubrication system trouble in general inspection

Before performing diagnostics, make sure that the engine oil level is correct and no oil leakage exists.

Trouble

Possible cause

Corrective action

Warning light remains ON.

a. Oil pressure switch failure

Cracked diaphragm or oil leakage within switch

Replace.

Broken spring or seized contacts

Replace.

b. Low oil pressure

Clogging of oil filter

Replace.

Malfunction of oil by-pass valve in oil filter

Replace.

Clogged oil passage

Clean.

Excessive tip clearance and side clearance of oil pump rotor

Replace.

Clogged oil strainer or broken pipe

Clean or replace.

c. No oil pressure

Insufficient engine oil (degradation, etc.)

Replace.

Broken pipe of oil strainer

Replace.

Stuck oil pump rotor

Replace.

Warning light does not illuminate.

a. Malfunction of combination meter

Replace.

b. Poor contact of switch contact points

Replace.

c. Disconnection of wiring

Repair.

Warning light flickers momentarily.

a. Defective terminal contact

Repair.

b. Defective wiring harness

Repair.

c. Oil pressure switch failure

Cracked diaphragm or oil leakage within switch

Replace.

Broken spring or seized contacts

Replace.

d. Low oil pressure

Clogging of oil filter

Replace.

Malfunction of oil by-pass valve in oil filter

Replace.

Clogged oil passage

Clean.

Excessive tip clearance and side clearance of oil pump rotor

Replace.

Clogged oil strainer or broken pipe

Clean or replace.

Lubrication(h4do)
...

Oil pump specification
The oil pump cannot be disassembled.Refer to “Chain Cover” for removal and installation procedures. Chain Cover > REMOVAL Chain Cover > INSTALLATION ...

Other materials:

Dtc b1763 occupant detection module calibration checksum
DTC DETECTING CONDITION:• Malfunction is detected on vehicle delivery or at memory writing for «Rezero».• Occupant detection control module is faulty.STEPCHECKYESNO1.CHECK DTC.Read the DTC of the occupant detection system. Read Diagnostic Trouble Code (DTC)Are DTCs other than DTC B176 ...

© 2017-2024 Copyright www.sulegacy.com