Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
CAUTION: Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents. 1. If there is damage or defectiveness in the facing sliding surface or ring gear, replace the flywheel.
2. Smoothness of rotation Rotate the ball bearing while applying pressure in the thrust direction. 3. If any noise or excessive play is noted, replace the pilot bearing. |
Removal
1. Remove the transmission assembly. Manual Transmission Assembly > REMOVAL2. Remove the clutch cover and clutch disc. Clutch Disc and Cover > REMOVAL3. Attach the ST.ST 498497100CRANKSHAFT STOPP ...
Installation
1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the bearing inner ring.(A)Pilot bearing2. T ...
Other materials:
Assembly
NOTE:If the brake hose is disconnected, air enters inside. Therefore, this operation should be performed on the vehicle without the brake hose disconnected.1. Check each part. Rear Disc Brake Assembly > INSPECTION2. Install the bushing.3. Using the ST, install the piston boot.Preparation tool:ST: P ...
© 2017-2024 Copyright www.sulegacy.com
