Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission(tr690) / Torque converter assembly / Inspection

• Check the protrusion of torque converter center (front boss) is not deformed or damaged.

• Check the ring gear and exterior for break or damage.

Removal

1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL2. Pull out the torque converter assembly horizontally.CAUTION:Do not scratch the inside of engaging par ...

Installation

1. Install the O-ring to front reduction drive gear.NOTE:• Use new O-rings.• Apply CVTF to the O-rings.2. While holding the torque converter assembly by hand, carefully install it into the ...

Other materials:

Dtc p0050 a/f / o2 heater control circuit bank 2 sensor 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...