1.CHECK ENGINE OIL LEVEL. | Is engine oil level normal- | Oil Level Switch > INSPECTION | Replace engine oil or refill, and check again while the oil level is normal condition. Engine Oil > REPLACEMENT To disable the low engine oil warning, install the spare fuse at the delivery mode fuse in the main fuse box. Then turn the ignition switch to ON (engine off) again, to confirm the low engine oil warning is not displayed. Remove the spare fuse installed to finish. NOTE: The engine oil level switch is normal if the low engine oil level warning is not displayed with the delivery mode fuse inserted. |
| Has a DTC of the LAN system been input- | Perform the diagnosis according to DTC. | Oil Level Switch > INSPECTION |
3.CHECK OIL LEVEL SWITCH CIRCUIT. 1) Turn the ignition switch to ON (engine OFF). 2) Read the current data for engine in the Subaru Select Monitor to confirm the item for “Oil level switch”. Subaru Select Monitor > OPERATION | Is the “Oil level switch” signal displayed in Subaru Select Monitor HIGH- | To disable the low engine oil warning, install the spare fuse at the delivery mode fuse in the main fuse box. Then turn the ignition switch to ON (engine off) again, to confirm the low engine oil warning is not displayed. Remove the spare fuse installed to finish. NOTE: The engine oil level switch is normal if the low engine oil level warning is not displayed with the delivery mode fuse inserted. | Oil Level Switch > INSPECTION |
4.CHECK COMBINATION METER. Perform the self-diagnosis of combination meter to check if there are any faults in the combination meter. Combination Meter System > OPERATION | | Oil Level Switch > INSPECTION | Replace the combination meter. Combination Meter > REMOVAL |
5.CHECK SECURE CONNECTION OF CONNECTOR BETWEEN ENGINE HARNESS AND OIL LEVEL SWITCH. | Is there any insecure connection- | Repair the connection condition. Then, to disable the low engine oil warning display, install the spare fuse at the delivery mode fuse in the main fuse box. Then turn the ignition switch to ON (engine OFF) again to confirm the low engine oil warning is not displayed. Remove the spare fuse installed to finish. NOTE: The engine oil level switch is normal if the low engine oil level warning is not displayed with the delivery mode fuse inserted. | Oil Level Switch > INSPECTION |
6.CHECK OIL LEVEL SWITCH. 1) Deliberately short circuits by connecting the engine harness connector terminal and chassis ground. 2) Turn the ignition switch to ON (engine OFF). 3) Read the current data for engine in the Subaru Select Monitor to confirm the item for “Oil level switch”. Subaru Select Monitor > OPERATION Connector & terminal (E130) No. 1 — Chassis ground: | Is the “Oil level switch” signal displayed in Subaru Select Monitor HIGH- | Replace the oil level switch. Oil Level Switch > REMOVAL | Oil Level Switch > INSPECTION |
7.CHECK SECURE CONNECTION OF CONNECTOR BETWEEN ENGINE CONTROL MODULE (ECM) AND ENGINE HARNESS. | Is there any insecure connection- | Repair the connection condition. Then, to disable the low engine oil warning display, install the spare fuse at the delivery mode fuse in the main fuse box. Then turn the ignition switch to ON (engine OFF) again to confirm the low engine oil warning is not displayed. Remove the spare fuse installed to finish. NOTE: The engine oil level switch is normal if the low engine oil level warning is not displayed with the delivery mode fuse inserted. | Oil Level Switch > INSPECTION |
8.CHECK ENGINE HARNESS. 1) Disconnect the engine control module (ECM) side connector. 2) Set the ST between the engine control module (ECM) and engine harness. General Description > CAUTION 3) Disconnect the connector between the engine harness and the oil level switch. 4) Measure the resistance between connector terminals. Connector & terminal (B158) No. 3 — (B130) No. 1: | Is the resistance less than 1 -- | Replace the engine control module (ECM). Engine Control Module (ECM) > REMOVAL | Repair or replace the open circuit of engine harness. |
Wiring diagram
Removal