Subaru Legacy BN/BS (2015-2019) Service Manual: Installation

Subaru Legacy BN/BS (2015-2019) Service Manual / Fuel injection (fuel systems)(h4do) / Manifold absolute pressure sensor / Installation

1. Install the manifold absolute pressure sensor to the intake manifold assembly, and connect the connector to the manifold absolute pressure sensor.

NOTE:

Use new O-rings.

Tightening torque:

3.4 N·m (0.3 kgf-m, 2.5 ft-lb)

2. Connect the ground terminal to battery sensor. NOTE

Inspection

1. Check that the manifold absolute pressure sensor has no deformation, cracks or other damages.2. Connect dry-cell battery positive terminal to terminal No. 3 and dry-cell battery ground terminal to ...

Mass air flow and intake air temperature sensor

...

Other materials:

Forced drive
CAUTION:After a forced operation, make sure to perform an initialize operation. Sunroof Control System > OPERATIONIf the lid assembly - sunroof does not operate or the motor assembly is not supplied with power, remove the motor assembly to move the lid assembly - sunroof manually.1. Remove the over ...