Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. TOUCH SENSOR UPR 1. Install the power rear gate touch sensor UPR. (1) Clean the bracket surface of the touch sensor UPR to remove dust and dirt fully. (2) Using a sponge, apply primer to the bracket surface of the touch sensor UPR that is not covered with masking tape. CAUTION: • Do not apply primer beyond masking tape. This may cause discolored touch sensor UPR bracket. • Dry the primered surface for approx. 10 minutes without touching it. Primer: 3M 4298-UV or equivalent (3) Install the touch sensor UPR. CAUTION: When affix the touch sensor UPR, do not use tools. 1. Affix a new touch sensor UPR along the masking tape. 2. Press-fit the touch sensor UPR securely and remove the masking tape. 2. Install the power rear gate touch sensor LWR. Power Rear Gate Touch Sensor > INSTALLATION 3. Connect the ground terminal to battery sensor. NOTE 2. TOUCH SENSOR LWR 1. Install the power rear gate touch sensor LWR. CAUTION: • Make sure the electrical connector is connected securely. • When installing the touch sensor LWR, be careful not to get the connector or harness crimped or deformed. Tightening torque: 1.5 N·m (0.2 kgf-m, 1.1 ft-lb) 2. Install the trim panel - rear gate. 3. Connect the ground terminal to battery sensor. NOTE |
Removal
1. TOUCH SENSOR UPR1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the touch sensor LWR. Power Rear Gate Touch Sensor > REMOVAL3. Remove the power rear gate touch sensor UPR.CAU ...
Relay and fuse
...
Other materials:
Fuel procedure
1. RELEASING OF FUEL PRESSUREWARNING:Place “NO OPEN FLAMES” signs near the working area.CAUTION:Be careful not to spill fuel.1. Remove the fuse of fuel pump from main fuse box.2. Start the engine and run it until it stalls.3. After the engine stalls, crank it for five more seconds.4. Tur ...
