Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. SEAT BELT OUTER - FRONT CAUTION: • Refer to “CAUTION” of “General Description” before handling the airbag system components. General Description > CAUTION • The parts of the driver and passenger sides are not the same. Before installation, make sure that the correct part is used. • During installation, make sure that the seat belts are not twisted. • After installation, make sure that the seat belt can be pulled out and retracted smoothly. • Make sure that the seat belt harness is not caught anywhere. Wrong harness rooting may cause the harness short from pinch. • If the hook - rear seat is disconnected from the vehicle body, make sure to replace the hook - rear seat with a new part to prevent the decline of the fixed force of the seat.
1. Before installation, perform a unit inspection of retractor. Front Seat Belt > INSPECTION 2. Install the adjuster assembly - seat belt and the seat belt outer - front. Tightening torque: Refer to “COMPONENT” of “General Description”. General Description > COMPONENT 3. Install the trim panel - rear pillar UPR. Tightening torque: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb) 4. Install the trim panel - center pillar LWR, cover side sill - front, and cover side sill - rear. 5. Install the rear seat cushion assembly. 6. Connect the ground terminal to battery sensor. NOTE 7. After installation, check the following points. • The seat belt is not twisted. • The seat belt can be pulled out and retracted smoothly. • The adjuster assembly - seat belt can be moved smoothly. • Check that the airbag warning light lights up for approximately 6 seconds and then turns off when connecting the battery ground cable and turning the ignition switch to ON. 2. SEAT BELT INNER - FRONT CAUTION: • Before installation, make sure that the correct part is used. • During installation, make sure that the seat belts are not twisted. • Check that there is no pinching of the seat belt harness. Wrong harness rooting may cause the harness short from pinch. • Do not forget the wave washer, when installing front seat inner belt assembly. 1. Install the seat belt inner - front. Tightening torque: 53 N·m (5.4 kgf-m, 39.1 ft-lb) 2. Install the seat assembly to the body. Front Seat > INSTALLATION 3. Connect the ground terminal to battery sensor. NOTE |
Inspection
1. VISUAL INSPECTIONCheck for the following, and replace with new parts if necessary.• Pretensioner is cracked or deformed.• Adjuster assembly - seat belt is cracked or deformed.• Se ...
Other materials:
Adjustment
1. INTAKE SIDE1. Remove the engine from the vehicle. Engine Assembly > REMOVAL2. Measure all the valve clearances. Valve Clearance > INSPECTIONNOTE:Record each valve clearance after measurement.3. Remove the timing chain assembly. Timing Chain Assembly > REMOVAL4. Remove the cam sprocket. Cam Sp ...
