Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. TRANSMITTER (TIRE INFLATION PRESSURE SENSOR) CAUTION: Use the new transmitter assembly or replace the new valve and screw, when installing. 1. Replace the valve and screw with a new part when reusing transmitter.
Tightening torque: 1.4 N·m (0.1 kgf-m, 1.0 ft-lb) 2. Install the transmitter to the wheel by aligning it with valve hole. NOTE: When using the jig that pulls the valve cap by hooking its neck part, use another short-type cap. 3. Install the tires to wheels. CAUTION: • Use a tire changer when installing tire to wheel. • To prevent damaging the transmitter, set the tire changer boom in the position as shown in the figure.
4. Install the wheels to vehicle. Tire and Wheel > INSTALLATION 5. Register the transmitter ID to the TPMS & keyless control module. Register Transmitter (ID) 2. TPMS & KEYLESS CONTROL MODULE NOTE: • TPMS control module for model without keyless access with push button start system is integrated with the keyless entry control module. For removal procedures, refer to “SECURITY AND LOCKS” section. Keyless Entry Control Module > REMOVAL • Re-register the key and the transmitter ID when TPMS & keyless entry control module has been replaced. • Keyless transmitter re-registration: Keyless Transmitter > REPLACEMENT • Transmitter ID re-registration: Register Transmitter (ID) 3. TPMS CM NOTE: • TPMS control module for model with keyless access with push button start system is installed in the same position as the keyless entry control module for model without keyless access with push button start system. For removal procedures, refer to “SECURITY AND LOCKS” section. Keyless Entry Control Module > REMOVAL • Re-register the transmitter ID when the TPMS control module has been replaced. Register Transmitter (ID) |
Adjustment
Re-register the transmitter ID when transmitter has been replaced. Register Transmitter (ID) ...
Wiring system
...
Other materials:
Component
(1)TPMS & keyless entry control module (model without keyless access with push button start system)(4)Transmitter (snap in type)Tightening torque: N·m (kgf-m, ft-lb)(2)TPMS CM (model with keyless access with push button start system)(5)ValveT1:1.4 (0.1, 1.0)(3)Screw T2:7.5 (0.8, 5.5)(1)TPMS ...
