Subaru Legacy BN/BS (2015-2019) Owners Manual: Loading your vehicle

Subaru Legacy BN/BS (2015-2019) Owners Manual / Driving tips / Loading your vehicle

WARNING Never allow passengers to ride on a folded rear seatback, in the trunk or in the cargo area. Doing so may result in serious injury.

Loading your vehicle

WARNING

Never stack luggage or other cargo higher than the top of the seatback because it could tumble forward and injure passengers in the event of a sudden stop or accident. Keep luggage or cargo low, as close to the floor as possible.
When you carry something inside the vehicle, secure it whenever you can to prevent it from being thrown around inside the vehicle during sudden stops, sharp turns or in an accident.
Do not pile heavy loads on the roof. These loads raise the vehicle's center of gravity and make it more prone to tip over.
Secure long items properly to prevent them from shooting forward and causing serious injury during a sudden stop.
Never exceed the maximum load limit. If you do, some parts on your vehicle can break, or it can change the way your vehicle handles. This could result in loss of control and cause personal injury. Also, overloading can shorten the life of your vehicle.
Do not place anything on the rear shelf behind the rear seatback (Legacy) or the extended cargo area cover (Outback - i f equipped). Such items could tumble forward in the event of a sudden stop or a collision. This could cause serious injury.

CAUTION Do not carry spray cans, containers with flammable or corrosive liquids or any other dangerous items inside the vehicle.

NOTE For better fuel economy, do not carry unneeded cargo.

Rocking the vehicle

If you must rock the vehicle to free it from snow, sand, or mud, depress the accelerator pedal slightly and move the shift lever/select lever back and forth between "1"/"D" and "R" repeatedly. Do ...

Vehicle capacity weight

The load capacity of your vehicle is determined by weight, not by available cargo space. The maximum load you can carry in your vehicle is shown on the vehicle placard attached to the driver's ...

Other materials:

Dtc b2a0b green led circuit
DIAGNOSIS START CONDITION: When ACC is ON.DTC DETECTING CONDITION:• Current in LED is less than 1 mA. (Improper LED connection, etc.)• Current is more than 200 mA for at least 50 ms. (Short-circuited LED, etc.)TROUBLE SYMPTOM:RED LED illuminates.WIRING DIAGRAM:NOTE:For the coupling conne ...