1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Combination Meter» and then select «Enter». 5. On «Select Function» display, select «Active Test». 6. On «Active Test» display, select an item to be checked. NOTE: • For detailed operation procedures, refer to “Application help”. • If not equipped (depending on destination area or vehicle equipment condition), process will not go on. CAUTION: After executing the system operation check mode, execute the Clear Memory Mode. Clear Memory Mode |
Inspection
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the clip (A), and loosen the clamps (B) and (C).3. Remove the air intake boot, and move it to the left side wheel apron.4. Disconnect the transmission radio ground terminal and transmission harness connector, and remove the harnes ...