Subaru Legacy BN/BS (2015-2019) Service Manual: Operation
If the EyeSight pause code is detected from the stereo camera, all the functions of the EyeSight excluding the conventional cruise control stop temporarily and cannot be used. When the failure is resolved, the function starts operating. 1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «EyeSight» and select «Enter». 5. On «Select Function» display, select «Cancel Code». 6. On «Cancel Code» display, select «EyeSight Pause Code». NOTE: • For detailed operation procedures, refer to “Application help”. • Temporary stop is not released even if the lane departure warning OFF switch or pre-collision brake OFF switch is pressed. • Depending on the situation, temporary stop may not be released even if the ignition switch is turned off. • Up to 20 codes can be stored. • Stored codes will be cleared by Clear Memory. • For details on EyeSight temporary stop codes, refer to List of EyeSight temporary stop code. EyeSight Temporary Code(s) Display > LIST |
List
• List of EyeSight temporary stop codeEyeSight pause codeItemContents of diagnosisReferenceE5Stereo Camera Temporary StopThe operation stopped temporarily due to vertical deviation of the optica ...
Other materials:
Caution
1. AIRBAG SYSTEMAirbag system wiring harness is routed near the cruise control command switch.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits.• Be careful not to damage the airbag system wiring harness when servicing the cru ...
