1. BRAKE LAMP LIGHTING OPERATION MODE BY SUBARU SELECT MONITOR CAUTION: By executing the compulsory operation for the brake lamp relay, the electronic parking brake warning light may illuminate. After the brake light relay compulsory operation is executed, refer to “Basic Diagnostic Procedure” of “Vehicle Dynamics Control (VDC) (DIAGNOSTICS)” and check DTCs and then clear memory. Basic Diagnostic Procedure NOTE: In the event of any trouble, brake lamp lighting operation mode will not function. 1. Connect the Subaru Select Monitor to data link connector. NOTE: For detailed operation procedures, refer to “Application help”. (1) On «Start» display, select «Diagnosis». (2) On «Vehicle selection» display, input the target vehicle information and select «Confirmed». (3) On «Main Menu» display, select «Each System». (4) On «Select System» display, select «Brake Control System» and select «Enter». (5) On «Select Function» display, select «Work Support». (6) From «Work Support», select «Brake Lamp Lighting Operation». 2. Operate according to the procedures displayed in the Subaru Select Monitor. |
Windshield wipers
: Mist (for a single wipe)
: Off
: Intermittent
: Low speed
: High speed
To turn the wipers on, push the wiper
control lever down.
To turn the wipers off, return the lever to
the " " position.
For a single wipe of the wipers, push the
lever up. The wipers operate until you
release ...