1. On «Start» display, select «Diagnosis». 2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed». 3. On «Main Menu» display, select «Each System». 4. On «Select System» display, select «Subaru Rear Vehicle Detection(RH)» or «Subaru Rear Vehicle Detection(LH)» and then select «Enter». 5. On «Select Function» display, select «Active Test». NOTE: For detailed operation procedures, refer to “Application help”. |
Preparation for overhaul procedure
1. Clean oil, grease, dirt and dust from the transmission.2. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.3. Tighten the drain plug using TORX® bit T70.NOTE:Use a new gasket.Tightening torque:44 N·m (4.5 kgf-m, 32.5 ft-lb) (aluminum gasket, ...