CAUTION: • Be careful not to spill the brake fluid. Brake fluid spilled on the vehicle body will harm the paint surface; wash it off with water and wipe clean quickly if spilled. • Use new FMVSS No. 116 DOT3 or DOT4. • Cover the air bleeder with cloth to prevent brake fluid from being splashed on surrounding parts when loosening the bleeder. • Avoid mixing brake fluid of different brands to prevent fluid performance from degrading. • Be careful not to allow dirt or dust to enter the reservoir tank. NOTE: • During the bleeding operation, keep the reservoir tank filled with brake fluid to prevent entry of air. • Clutch pedal must be operated very slowly. • Bleed air from the oil line with help of a co-worker. • The required amount of brake fluid is approximately 165 mL (5.6 US fl oz, 5.8 Imp fl oz) for total clutch system. 1. Remove the clip (A) from the air intake boot. 2. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear). 3. Loosen the clamp (C) which connects the air intake boot and throttle body. 4. Remove the air intake boot from the throttle body, and move it to the left side wheel apron. 5. Drain the brake fluid from the reservoir tank. 6. Refill the reservoir tank with recommended brake fluid. Recommended brake fluid: New FMVSS No. 116 DOT3 or DOT4 7. Bleed air from brake fluid. Clutch Fluid Air Bleeding 8. Install the air intake boot. Air Intake Boot > INSTALLATION |
Disassembly
1. RADIATOR MAIN FAN AND RADIATOR MAIN FAN MOTOR1. Disconnect the connector from the radiator fan control module (main), and remove the radiator main fan motor harness from the clip (A).2. Remove the radiator main fan from the radiator main fan motor.3. Remove the radiator main fan motor from the ra ...