Subaru Legacy BN/BS (2015-2019) Owners Manual: Replacing battery

Subaru Legacy BN/BS (2015-2019) Owners Manual / Maintenance and service / Replacing battery

The access key / transmitter battery may be discharged under the following conditions.

The operation of the keyless access function is unstable
The operating distance of the remote keyless entry system is unstable
The transmitter does not operate properly when used within the standard distance

Replace the battery with a new one.

CAUTION

Do not let dust, oil or water get on or in the access key/transmitter when replacing battery.
Be careful not to damage the printed circuit board in the access key/transmitter when replacing the battery.
Be careful not to allow children to touch the battery and any removed parts; children could swallow them.
There is a danger of an explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type of the battery.
Batteries shall not be exposed to excessive heat such as bright sunlight, fire or the like.

NOTE

Replace only with the same or equivalent type of battery recommended by the manufacturer.
Dispose of used batteries according to the local laws.
Mount the battery in the correct orientation to prevent fluid leakage.
Be careful not to bend the terminals. It may result in a malfunction.
It is recommended that the battery should be replaced by a SUBARU dealer.
Use a new battery.
After replacing the battery, confirm that the access key/transmitter functions properly.

Cargo area light (Outback)

Remove the lens by prying the edge of the lens with a flat-head screwdriver. Pull the bulb out of the socket. Install a new bulb. Reinstall the lens. Trunk light ...

Replacing battery of access key

CAUTION When removing or fitting the access key cover, make sure that the plastic part does not come off or become misaligned. Battery: Button battery CR2032 1) Release b ...

Other materials:

Dtc b1816 open in passenger's airbag dual stage - 2nd step
DIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Open circuit failure (open circuit in main harness, open circuit in passenger’s airbag, open circuit in airbag CM internal circuit, connector connection failure)CAUTION:Before performing diagnosis, refer to &ldq ...