Subaru Legacy BN/BS (2015-2019) Service Manual: Subaru select monitor operation
1. GENERAL DESCRIPTION The on-board diagnosis function of the cruise control system uses Subaru Select Monitor. The on-board diagnosis function operates in two categories, which are used depending on the type of problems; 1. Cruise Control Cancel Conditions Diagnosis: (1) This category of diagnosis requires actual vehicle driving in order to determine the cause, as when cruise speed is cancelled during driving although cruise cancel condition is not entered. (2) Cruise control memory in ECM stores the cancel code which occurred during driving. When there are multiple cancel code, they are shown on the Subaru Select Monitor. CAUTION: • In the cruise control memory, not only the cruise control “cancel” occurred (although the “cancel” operation is not entered by the driver), but also the “cancel” condition input by the driver is stored. • The latest memory content (latest code) is cleared when ignition switch is turned to OFF. However, memory contents set by the diagnosis of faulty switches related to the system and cruise control will remain as trouble history (memory code) after the ignition switch is turned to OFF. 2. Real-time Diagnosis: Real-time diagnosis function is used to determine whether or not the input signal system is in good order, according to signal emitted from switches, sensors, etc. (1) Vehicle cannot be driven at cruise speed when the problem occurs in the cruise control system or relevant circuits. (2) Monitor the signal conditions from switches and sensors. 2. BASIC OPERATION For operation procedures, refer to the “PC application help for Subaru Select Monitor”. |
Real-time diagnosis operation
1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. ...
Other materials:
Removal
1. Lift up the vehicle, and then remove the rear wheels.2. Remove the trailing link. Rear Trailing Link > REMOVAL3. Remove the lateral link assembly - front.(1) Remove the snap pin (a) and nut (b).(2) Remove the ball joint from the housing assembly - rear axle.Preparation tool:Tie-rod ball joint pu ...
