Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Owners Manual: To hook the top tether

Subaru Legacy BN/BS (2015-2019) Owners Manual / Seat, seatbelt and SRS airbags / Child restraint systems / Top tether anchorages / To hook the top tether

CAUTION Always raise the head restraint when mounting a child restraint system with a top tether. Failure to do so may prevent the top tether from being fastened tightly.

Legacy

To hook the top tether

1) When installing on the window-side seating position
2) When installing on the rear center seating position

  1.  Raise the head restraint at the seating position where the child restraint system is to be installed with the seatbelt or lower anchorages.

To hook the top tether

  1. Open the cover flaps to use the anchorages.
  2.  Pass the top tether between the head restraint and seatback.

To hook the top tether

  1. Fasten the top tether hook of the child restraint system to the appropriate upper anchorage.
  2.  Tighten the top tether securely.

To hook the top tether

1) When installing on the window-side seating position
2) When installing on the rear center seating position

  1.  Raise the head restraint at the seating position where the child restraint system is to be installed with the seatbelt or lower anchorages.
  2.  Adjust the seatback to the upright position.
  3.  Pass the top tether between the head restraint and seatback.

To hook the top tether

  1. Attach the top tether hook to the appropriate upper anchorage.
  2.  Tighten the top tether securely.
Tether anchorage location
Legacy Three tether anchorages are installed on the rear shelf behind the rear seat head restraint. Open the cover flap to use each anchorage. Outback For left seat  For center ...

SRS airbag (Supplemental Restraint System airbag)
*SRS: This stands for Supplemental Restraint System. This name is used because the airbag system supplements the vehicle's seatbelts. Your vehicle is equipped with a supplemental restraint syst ...

Other materials:

Installation
1. Install the transfer drive gear.Tightening torque:26 N·m (2.7 kgf-m, 19.2 ft-lb)2. Install the transfer driven gear. Transfer Driven Gear > INSTALLATION3. Select the adjusting washer. Transfer Case and Extension Case Assembly > INSTALLATION4. Install the transfer case and the extension c ...

© 2017-2025 Copyright www.sulegacy.com