Subaru Legacy BN/BS (2015-2019) Owners Manual: Unfastening the seatbelt

- Push the release button of the center
seatbelt buckle (on the left-hand side) to
unfasten the seatbelt.


- Insert a tongue plate or other hard
pointed object into the slot in the connector
(buckle) on the right-hand side and
push it in. The connector (tongue) plate
will then disconnect from the buckle.

- Allow the retractor to roll up the belt.
You should hold the webbing end and
guide it back into the retractor while it is
rolling up. Neatly store the tongue plate in
the recess and then insert the connector
(tongue) plate into the slot.

| CAUTION
Observe the following precautions.
Otherwise, the tongue plate can hit
against the trim, causing damage to
the trim.
- Do not allow the retractor to roll
up the seatbelt too quickly.
- Have the seatbelt fully rolled up
so that the tongue plates are
neatly stored.
|
|
Center seatbelt tongue plate
Connector (tongue)
Connector (buckle)
Center seatbelt buckle
WARNING
Fastening the seatbelt with the webbing
twisted can ...
To clean the seatbelts, use a mild soap
and lukewarm water. Never bleach or dye
the belts because this could seriously
affect their strength.
Inspect the seatbelts and attachments
including the ...
Other materials:
Dtc b1576 egi control module eeprom
DIAGNOSIS START CONDITION:• Battery voltage is 10 V or more.• The remote engine starter was not used to start the engine.DTC DETECTING CONDITION:• ECM malfunctioning• Failed to access ROM in ECM during key registration.TROUBLE SYMPTOM:• Engine will not start.• The ...