Subaru Legacy BN/BS (2015-2019) Service Manual: Washer tank and motor

Inspection

1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.2. CHECK RELAY1. Measure the resistance between relay terminals.Terminal No.Inspection conditionsStan ...

Removal

1. WASHER TANK1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the bumper face - front. Front Bumper > REMOVAL3. Remove the tank - washer assembly.(1) Press the claw and remove t ...

Other materials:

Dtc p0019 crankshaft position - camshaft position correlation bank 2 sensor b
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Engine stalls.• Improper idlingCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCE ...