Subaru Legacy BN/BS (2015-2019) Service Manual: Combination meter (diagnostics)
Subaru Legacy BN/BS (2015-2019) Service Manual / Combination meter (diagnostics)
- Basic diagnostic procedure procedure
- Check list for interview check
- Clear memory mode operation
- Control module i o signal electrical specification
- Electrical component location location
- Inspection mode operation
- List of diagnostic trouble code (dtc) list
- Read diagnostic trouble code (dtc) operation
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc u1433 invalid data received from eyesight
- Dtc u0100 lost communication with ecm/pcm "a"
- Dtc u1235 lost communication with eyesight
- Dtc u0073 control module communication bus off
- Dtc b1507 external air temperature open/short-circuit detection
- Dtc b1500 fuel sender open/short-circuit detection
- Dtc u0327 software incompatibility with vehicle security control module
- Dtc u0181 lost communication with headlamp leveling control module
- Dtc b1502 warning box communication malfunction
- Dtc u0151 lost communication with restraints control module
- Dtc u0140 lost communication with body control module
- Dtc u0131 lost communication with power steering control module
- Dtc u0128 lost communication with park brake control module
- Dtc u0122 lost communication with vehicle dynamics control module
- Dtc u1232 lost communication with rear/side radar control module
- Dtc u0162 lost communication with audio visual navigation display module
- Dtc u0101 lost communication with tcm
- General description
- Read current data
- Subaru select monitor
- System operation check mode
- User customizing
Installation
NOTE:Apply the specified grease to lubricate to the following points before installation.• Contact surface of lever and pivot• Contact surface of lever and bearing• Transmission main ...
Basic diagnostic procedure procedure
STEPCHECKYESNO1.PERFORM CUSTOMER INTERVIEW.Using the Check List for Interview, ask the customer the condition of how trouble occurs. Check List for Interview > CHECKDid you interview the customer- Ba ...
Other materials:
Disassembly
1. Remove the cap from the generator.2. Remove four bolts.3. Use a drier to heat the rear cover (A) portion to 50 — 60°C (122 — 140°F).4. Insert a flat tip screwdriver or similar tool wrapped with protective tape into the gap between stator core and the front cover to disassemble.( ...
© 2017-2024 Copyright www.sulegacy.com
