Subaru Legacy BN/BS (2015-2019) Service Manual: Hvac system (heater ventilator and a c)
Subaru Legacy BN/BS (2015-2019) Service Manual / Hvac system (heater ventilator and a c)
- Diagnostics with phenomenon inspection
- Pressure sensor inspection
- Refrigerant charging procedure procedure
- Refrigerant leak check inspection
- Refrigerant recovery procedure procedure
- A c filter
- Air conditioning system
- Air mix door actuator
- Air vent grille
- Ambient sensor
- Blower motor
- Blower motor unit assembly
- Blower resistor (manual a c model)
- Compressor
- Compressor oil
- Condenser
- Control panel
- Control unit
- Evaporator
- Evaporator sensor
- Expansion valve
- Fresh recirc door actuator
- General description
- Heater and cooling unit
- Heater core
- Heater duct
- Heater vent duct
- Hose and pipe
- In-vehicle sensor (auto a c model)
- Mode door actuator
- Power transistor (auto a c model)
- Rear vent door actuator
- Refrigerant pressure with manifold gauge set
- Relay and fuse
- Sunload sensor (auto a c model)
List
NOTE:If not equipped (based on area or condition), some items are not displayed.System operation check mode itemDisplayUnitNoteIn-vehicle Air Temperature setting-72.47 — 193.82°C — Ambient ...
Diagnostics with phenomenon inspection
Refer to “Diagnostics with Phenomenon” of “HVAC SYSTEM (DIAGNOSTICS)” section. Diagnostics with Phenomenon ...
Other materials:
Electrical specification
CAUTION:Never remove the occupant detection control module, occupant detection sensor or seat frame because they are integrated into one unit.Terminal No.Description1Belt tension sensor output2Belt tension sensor power supply3GND4Seat belt buckle switch output5LIN communication line (airbag CM)6Igni ...
© 2017-2025 Copyright www.sulegacy.com
