Subaru Legacy BN/BS (2015-2019) Service Manual: Mechanical(h6do)
Subaru Legacy BN/BS (2015-2019) Service Manual / Mechanical(h6do)
- Compression inspection
- Connecting rod specification
- Crankshaft specification
- Engine noise inspection
- Engine oil pressure inspection
- Engine trouble in general inspection
- Fuel pressure inspection
- Idle speed inspection
- Ignition timing inspection
- Intake and exhaust valve specification
- Intake manifold vacuum inspection
- Piston specification
- Preparation for overhaul procedure
- Cam sprocket
- Camshaft
- Chain cover
- Crank pulley
- Crank sprocket
- Cylinder block
- Cylinder head
- Engine assembly
- Engine mounting
- General description
- Oil flow control solenoid valve
- Timing chain assembly
- Valve clearance
- V-belt
Installation
1. V-BELT1. Attach the tool to the V-belt tensioner assembly, and rotate the tool clockwise to remove the V-belt as shown in the figure.CAUTION:• When reusing the V-belt, wipe off dust and water ...
Compression inspection
CAUTION:After warming-up, engine becomes very hot. Be careful not to burn yourself during measurement.NOTE:• Before checking the compression pressure, the compression condition of each cylinder ...
Other materials:
Assembly
1. Install the O-ring to plug and install the plug to drive pinion retainer.NOTE:• Use new O-rings.• Apply CVTF to the O-rings.Tightening torque:25 N·m (2.5 kgf-m, 18.4 ft-lb)2. Using the ST, install the oil seal to drive pinion retainer.NOTE:• Apply CVTF to the oil seal pre ...
© 2017-2025 Copyright www.sulegacy.com
