1.PERFORM CUSTOMER INTERVIEW. Using the Check List for Interview, ask the customer the condition of how the trouble occurred. Check List for Interview > CHECK | Did you interview the customer- | Basic Diagnostic Procedure > PROCEDURE | Interview the customer. Check List for Interview > CHECK |
2.CHECK SUBARU SELECT MONITOR COMMUNICATION. Using the Subaru Select Monitor, check whether communication to the telematics system can be executed. NOTE: If the communication function of the Subaru Select Monitor cannot be executed properly, check the communication circuit. (Refer to "Communication for initializing impossible".) Subaru Select Monitor > INSPECTION | Is communication possible- | Basic Diagnostic Procedure > PROCEDURE | Check the communication circuit. |
3.CHECK TELEMATICS. Using the Subaru Select Monitor, read DTC of the telematics system. Diagnostic Code(s) Display > OPERATION NOTE: If DTC is detected, only RED LED will illuminate. For details, refer to "LED operation status list". Check List for Interview > CHECK | | Perform the diagnosis according to DTC. Diagnostic Code(s) Display > LIST | Basic Diagnostic Procedure > PROCEDURE |
4.CHECK DIAGNOSTICS WITH PHENOMENON. Check the list of Diagnostics with Phenomenon. Diagnostics with Phenomenon | | Perform diagnosis according to the procedures in the diagnostics with phenomenon. | Basic Diagnostic Procedure > PROCEDURE |
5.CHECK TROUBLE PHENOMENON. 1) Perform the basic inspection and function check. General Description > INSPECTION 2) Check the data communication module. Control Module I/O Signal 3) Perform check of current data. Read Current Data | Was the trouble cause found- | Perform the Clear Memory after repairing or replacing the cause of trouble. Clear Memory Mode | |
Check list for interview check