Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Service Manual: Engine cooling system trouble in general inspection

Subaru Legacy BN/BS (2015-2019) Service Manual / Cooling(h6do) / Engine cooling system trouble in general inspection

Trouble

Possible cause

Corrective action

Over-heating

a. Insufficient engine coolant

Replenish engine coolant, inspect for leakage, and repair it if necessary.

b. Defective thermostat

Replace.

c. Malfunction of water pump

Replace.

d. Clogged engine coolant passage

Clean.

e. Improper ignition timing

Inspect and repair ignition control system. Basic Diagnostic Procedure > PROCEDURE

f. Clogged or leaking radiator

Clean, repair or replace.

g. Defective radiator cap

Replace.

h. Improper engine oil in engine coolant

Replace the engine coolant. If ineffective, check, repair or replace engine components.

i. Air/fuel mixture ratio too lean

Inspect and repair the fuel injection system. Basic Diagnostic Procedure > PROCEDURE

j. Excessive back pressure in exhaust system

Clean or replace.

k. Insufficient clearance between piston and cylinder

Adjust or replace.

l. Dragging brake

Adjust.

m. Defective radiator fan

Check the radiator fan relay, control module, engine coolant temperature sensor or fan motor, and replace if necessary.

Over-cooling

a. Ambient temperature extremely low

Partly cover radiator front area.

b. Defective thermostat

Replace.

Engine coolant leaks

a. Loosened or damaged connecting units on hoses

Repair or replace.

b. Leakage from water pump

Replace.

c. Leakage from water pipe

Repair or replace.

d. Leakage around cylinder head gasket

Retighten cylinder head bolts or replace cylinder head gasket.

e. Damaged or cracked cylinder head and cylinder block

Repair or replace.

f. Damaged or cracked thermostat cover

Repair or replace.

g. Leakage from radiator

Repair or replace.

Noise

a. Defective radiator fan

Replace.

b. Defective water pump bearing

Replace water pump.

c. Defective water pump mechanical seal

Replace water pump.

Cooling(h6do)
...

Radiator cap inspection
1. Check that the radiator cap does not have deformation, cracks or damage.2. Attach the radiator cap tester to radiator cap.3. Check the maximum pressure while pumping the radiator cap tester several ...

Other materials:

Assembly
1. BUSHING - REAR AXLE HOUSINGDo not remove the housing assembly - rear axle because the bushing - rear axle housing cannot be replaced. If it is removed, replace the housing assembly - rear axle.2. BUSHING - TRAILING LINK1. Before assembly, inspect the following items and replace any faulty part wi ...

© 2017-2024 Copyright www.sulegacy.com