Subaru Legacy BN/BS (2015-2019) Service Manual: Inspection
1. Check and clean the rubber assembly - wiper. CAUTION: • Do not use organic solvent-based cleaner when cleaning rubber parts in order to avoid rubber part deterioration. • Do not continue to use damaged blade rubber. The windshield glass may be damaged. If the wiping performance decreases or any distinct streak is found, replace it as soon as possible. • Clean rubber parts using a soft cloth or paper towel dampened with windshield washer fluid or mild synthetic detergent. • Use Subaru genuine part only for wiper blade body and blade rubber. For model with EyeSight, using the part other than genuine part will affect the recognition of the stereo camera, which may cause the function not to operate correctly. Replace the rubber assembly - wiper if rubber part hardening, deformation or damage is found. 2. Operate the washer system to check if a chattering sound or insufficient wiping occurs. 3. If a chattering sound or insufficient wiping occurs, perform the following procedures. (1) Make sure that the blade assembly - wiper is not deformed and the movable part moves smoothly. (2) Remove oil film and dirt from the glass. CAUTION: • When powder-type glass cleaner is used, use after having been dissolved in water sufficiently. If it is used in less water, the glass surface may be damaged. • Clean the glass surface using a soft cloth or sponge with glass cleaner. (3) Operate the windshield wiper again. If a chattering sound or insufficient wiping occurs, perform the procedures again. 4. If defective is not improved after performing step 1) to step 3), replace the rubber assembly - wiper with a new part. |
Installation
Install each part in the reverse order of removal.CAUTION:Make sure the locking clip is secured.NOTE:Since the arm assembly - windshield wiper LH and RH can interfere with each other, install the pass ...
Disassembly
1. FRONTPull side (A) of the wiper rubber stopper, and remove the rubber assembly - windshield wiper from the blade assembly - windshield wiper.2. REARSlightly pull the top of the rubber assembly - re ...
Other materials:
Removal
1. CVT MODEL1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Remove the panel - knee guard. Steering Column > REMOVAL4. Remove ...
