NOTE: Before installation, remove mud and foreign matter from the disc brake assembly. 1. Install the pad - disc brake rear. 2. Install the caliper body assembly. Tightening torque: Caliper bolt: 25 N·m (2.5 kgf-m, 18.4 ft-lb) Brake hose bracket: 33 N·m (3.4 kgf-m, 24.3 ft-lb) 3. Connect the ground terminal to battery sensor. NOTE 4. Using the Subaru Select Monitor, exit the brake maintenance mode according to the display screen. Parking Brake System > OPERATION NOTE: For detailed operation procedures, refer to “Application help”. 5. After the operation is completed, apply and release the parking brake five times and ensure that the brake operates normally. 6. Install the rear wheels. Tightening torque: 120 N·m (12.2 kgf-m, 88.5 ft-lb) |
Inspection
CAUTION:Because the center pilot bearing is grease-sealed and is a non-lubrication type, do not wash with gasoline or solvents.1. If there is damage or defectiveness in the facing sliding surface or ring gear, replace the flywheel.(A)Flywheel(B)Ring gear2. Smoothness of rotationRotate the ball beari ...