Subaru Legacy BN/BS (2015-2019) Service Manual: Installation
1. POWER SEAT SWITCH 1. Install the switch assembly - power seat. 2. Install the switch assembly - lumber. (Model with lumber support) 3. Install the knob - power seat. 4. Install the cover - hinge front seat OUT. 5. Install the seat assembly. Front Seat > INSTALLATION 2. SEAT MEMORY SWITCH 1. Release the claws, and install the seat memory switch assembly. 2. Install the trim panel - front door. Door Trim > INSTALLATION 3. Connect the ground terminal to battery sensor. NOTE 3. POWER SEAT CONTROL MODULE (SEAT WITH MEMORY FUNCTION) 1. Install the power seat control module. Tightening torque: 5.9 N·m (0.6 kgf-m, 4.4 ft-lb) 2. Install the seat assembly. Front Seat > INSTALLATION 3. Raise the seat cushion by operating the switch. 4. Install the seat assembly. Front Seat > INSTALLATION NOTE: • The seat with memory function must be initialized after installed. Power Seat System > ADJUSTMENT • After replacing a seat with memory function and the power seat control module, check the following items. 1. Memory is reloaded by pressing the seat memory switch, when the ignition is ON and the select lever is set to the “P” range. 2. Memory is not reloaded even if the seat memory switch is pressed, when the ignition is ON and the select lever is set to other than “P” range. 3. Memory is reloaded when the ignition is OFF and the seat memory switch located inside the driver’s door is pressed within 45 seconds after the door is opened. 4. Memory is reloaded automatically when the ignition is OFF and the driver’s door is opened after unlocked by access key. (Model with smart key interlock function) |
Adjustment
NOTE:System calibration is necessary for driver’s side seat with memory function only.1. CONDITIONS FOR INITIALIZATIONThe power seat control module must be initialized if the following condition ...
Rear seat
...
Other materials:
Removal
Refer to “DISASSEMBLY” for removal procedures of scalp cap and mirror face. Outer Mirror Assembly > DISASSEMBLY1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. NOTE2. Remove the trim panel - front door. Door Trim > REMOV ...
