Subaru Legacy BN/BS (2015-2019) Service Manual: Adjustment
NOTE: System calibration is necessary for driver’s side seat with memory function only. 1. CONDITIONS FOR INITIALIZATION The power seat control module must be initialized if the following conditions are met. • The seat is removed from vehicle. • Power seat control module is replaced. • Slide rail assembly or backrest frame assembly is removed or replaced. • Pulse generated when seat is moved do not match with the amount of actual travel. (When memory is not correctly reloaded.) 2. INITIALIZATION PROCEDURES NOTE: • Initialize the records inside the module by performing all the following steps regardless the item order. • With each seat locked*, operating switches for 3 seconds make the buzzer sound once. • If initialization is done after completing all items, the buzzer sounds three times when the last operation is completed and the switch is turned on then off. 1. Move the seat rearward using the slide switch, and keep the seat lock* status for three seconds or more. 2. Move the seat downward using tilt switch, and keep the seat lock* status for three seconds or more. 3. Move the seat downward using lifter switch, and keep the seat lock* status for three seconds or more. 4. Move the seat forward using reclining switch, and keep the seat lock* status for three seconds or more. *: Seat lock is the status that there is no pulse output from the encoder within the specified period of time with the switch operated though the seat reaches the movable position end. NOTE: When the following conditions are met, the initializing operation is cancelled even though the procedure is carried out halfway. • Interval between each initialization procedure of 1) to 4) exceeds 10 seconds. • If any of initialization procedures 1) to 4) are not performed. • The battery runs out or the voltage to the power seat control module falls out of the operation range during initialization. |
Removal
CAUTION:When removing the front seat, disconnect the ground cable from the battery before disconnecting the airbag system and the occupant detection system harness connector, and wait for 60 seconds b ...
Installation
1. POWER SEAT SWITCH1. Install the switch assembly - power seat.2. Install the switch assembly - lumber. (Model with lumber support)3. Install the knob - power seat.4. Install the cover - hinge front ...
Other materials:
Removal
1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the cover assembly - instrument panel LWR driver. Instrument Panel Lower Cover > REMOVAL3. Remove the bolts, and then remove the panel - knee guard.4. Release the lock and remove the relay holder.5. Remove the auto headlight beam ...
