Subaru Legacy BN/BS (2015-2019) Service Manual: Main relay

Installation

1. Install the knock sensor to the cylinder block, and connect the connector to the knock sensor.NOTE:• Install the knock sensor connector so that the center of the connector is aligned with the ...

Removal

1. Disconnect the ground terminal from battery sensor. NOTE2. Remove the main relay from main fuse box. ...

Other materials:

Dtc p2097 post catalyst fuel trim system too rich bank 1
DTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Clear Memory Mode > OPERATION, and Inspection Mode Inspection Mode > PROCEDURE.WIRING DIAGRAM:• Engine Electrical System ENGINE T ...