Honda Civic manuals

Subaru Legacy BN/BS (2015-2019) Owners Manual: Recommended tire inflation pressure

Recommended cold tire inflation pressure

For the recommended cold tire inflation pressure for your vehicle's tires, refer to "Tires" F12-9.

Vehicle placard

Vehicle placard

The vehicle placard is affixed to the driver's side B-pillar.

Example:

Example

The vehicle placard shows original tire size, recommended cold tire inflation pressure on each tire at maximum loaded vehicle weight, seating capacity and loading information.

Adverse safety consequences of under-inflation

Driving at high speeds with excessively low tire pressures can cause the tires to flex severely and to rapidly become hot. A sharp increase in temperature could cause tread separation, and failure of the tire(s). Possible resulting loss of vehicle control could lead to an accident.

Measuring and adjusting air pressure to achieve proper inflation

Check and, if necessary, adjust the pressure of each tire (including the spare) at least once a month and before any long journey. Check the tire pressures when the tires are cold. Use a pressure gauge to adjust the tire pressures to the specific values. Driving even a short distance warms up the tires and increases the tire pressures.

Also, the tire pressures are affected by the outside temperature. It is best to check tire pressure outdoors before driving the vehicle.

When a tire becomes warm, the air inside it expands, causing the tire pressure to increase. Be careful not to mistakenly release air from a warm tire to reduce its pressure.

Other markings
The following makings are also placed on the sidewall. Maximum permissible inflation pressure The maximum cold inflation pressure to which this tire may be inflated. For example, "350 kPa (51 P ...

Glossary of tire terminology
Accessory weight The combined weight (in excess of those standard items which may be replaced) of automatic transmission, power steering, power brakes, power windows, power seats, radio, an ...

Other materials:

Inspection
1. Measure the resistance between connector terminals.Preparation tool:Circuit testerConnectorTerminal No.Inspection conditionsStandard(a)1 — 3OpenLess than 1 -4 — 3CloseLess than 1 -(b)1 — 3Tilt downLess than 1 -4 — 3Tilt upLess than 1 -2. Replace the sunroof switch if the inspection result ...

© 2017-2024 Copyright www.sulegacy.com