Subaru Legacy BN/BS (2015-2019) Service Manual: Diagnostic procedure without diagnostic trouble code (dtc) check shift indicator

Subaru Legacy BN/BS (2015-2019) Service Manual / Continuously variable transmission (diagnostics) / Diagnostic procedure without diagnostic trouble code (dtc) check shift indicator

DIAGNOSIS:

• CAN communication is abnormal with the combination meter.

• Combination meter malfunction

TROUBLE SYMPTOM:

• Shift indicator does not display or remains displayed.

• Shift indicator display does not change.

STEP	CHECK	YES	NO
1.CHECK DTC. Read the DTC relating the TCM using the Subaru Select Monitor.	Is DTC U0155 or U0423 displayed-	Perform the self-diagnosis of combination meter.	Diagnostic Procedure without Diagnostic Trouble Code (DTC) > CHECK SHIFT INDICATOR
2.CHECK DTC. Read the DTC relating the TCM using the Subaru Select Monitor.	Are DTCs other than U0155 and U0423 displayed-	Perform the diagnosis according to DTC.	Diagnostic Procedure without Diagnostic Trouble Code (DTC) > CHECK SHIFT INDICATOR
3.CHECK COMBINATION METER. Read DTC of combination meter.	Is DTC displayed-	Perform the diagnosis according to DTC.	Diagnostic Procedure without Diagnostic Trouble Code (DTC) > CHECK SHIFT INDICATOR
4.CHECK TCM. 1) Operate the + side of the paddle shift switch. 2) Read the data of «Up Switch» using the Subaru Select Monitor.	Does it change between ON and OFF according to the operation-	Diagnostic Procedure without Diagnostic Trouble Code (DTC) > CHECK SHIFT INDICATOR	Check for poor contact between TCM and paddle shift UP switch, and repair the defective part.
5.CHECK TCM. 1) Operate the − side of the paddle shift switch. 2) Read the data of «Down Switch» using the Subaru Select Monitor.	Does it change between ON and OFF according to the operation-	Diagnostic Procedure without Diagnostic Trouble Code (DTC) > CHECK SHIFT INDICATOR	Check for poor contact between TCM and paddle shift down switch, and repair the defective part.
6.CHECK TCM. 1) Turn the ignition switch OFF, then turn it ON again. 2) Shift the select lever to manual mode. 3) Read the data of «Shift step in Manu. mode» using the Subaru Select Monitor.	Is “1” displayed-	Diagnostic Procedure without Diagnostic Trouble Code (DTC) > CHECK SHIFT INDICATOR	Perform the diagnosis according to DTC P0951. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0951 AUTO SHIFT MANUAL CONTROL CIRCUIT RANGE/PERFORMANCE
7.CHECK TCM. 1) Shift up the select lever. 2) Read the data of «Shift step in Manu. mode» using the Subaru Select Monitor.	Is “2” displayed-	Currently, shift indicator is normal.	Replace the TCM. Transmission Control Module (TCM) Transmission Control Module (TCM)

Diagnostic procedure for subaru select monitor communication communication for initializing impossible

DIAGNOSIS:Defective harness connectorTROUBLE SYMPTOM:Subaru Select Monitor communication failureWIRING DIAGRAM:• ENGINE TYPE FBCVT control system CVT Control System > WIRING DIAGRAM• ENGI ...

Diagnostics with phenomenon inspection

SymptomsFaulty partsEngine stalls when driving in “D” or “R” range, or selecting “N” > “D”, “N” > “R”.• Control valve&bull ...

Other materials:

Installation
CAUTION:• For parts which are not reusable, always use new parts.• Check the bushing for abnormal cracks, fatigue or damage.1. Install the strut mount - front at the upper side of the strut to the body, and tighten it with new flange nuts.Tightening torque:20 N·m (2.0 kgf-m, 14.8 ...